Answer:
Steps in making two toned pillow case
1. A.One body of fabric that is 27 “wide x 44” long . B . Trim piece that is 9”wide x 44”long C. Scissors D. Needle and thread E. Pins F. Tape measure G. Tailor’s chalk
2. A. Place the trim piece or the 9” coordinating fabric pretty -side up. B. On the top, place the 27” main fabric pretty side down aligning the top raw edges.
3. Take the body of the 27” fabric and start creating a little roll like sushi. Roll the fabric up to the center of the 9” coordinating fabric .
4. Take the bottom of the coordinating fabric and bring it up over the burrito. Align the raw edges with the raw edges of the other fabric. Pin in place along the raw edges.
5. After pinning the entire row start sewing it make a seam allowance of half inch .
6. Begin to tug at the fabric inside the burrito / sushi , pulling it out of the tube, until it looks like this.
7. Fold pillow case in half wrong sides together. Pin around the raw edges on the side and bottom of the pillow case. Stitch together down the side and across the bottom using ¼ seam allowance.
8. Flip the Pillowcase wrong side out and press the seams down. Pillowcase is facing right sides together. Pin the side and bottom seams. Stitch the side and bottom seams using a 1/2” seam allowance.
